Successful PCB Milling Experiment

I’ve been learning electronics on and off in the past couple of years and finally decided to try milling a PCB on the Taig CNC Mill.

“Hand” drawn PCB in Rhino with toolpaths done in MadCam.

Milling with a .020” carbide end mill.

Another shot.

Very clean, no burrs.

Holes drilled with a #59 carbide circuit board drill.

Soldered up and working. It’s an Attiny84 microprocessor driving an RGB LED with PWM so I can get a lovely mix of colors. The headers on either side of the chip are for reprogramming and additional utility. I'm using an Arduino to program the Attiny84.